Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 23)

Basic configuration of the web application
G&D DVICenter · 21
Basic configuration of the
web application
The tool symbol in the toolbar can be used to access the basic configuration of the
web application.
Network settings
The devices with integrated web application are provided with two network inter-
faces (Network A and Network B). These network interfaces enable you to integrate the
device into up to two separate networks.
Configuring the network settings
Configure the network settings to connect the device to a local network.
How to configure the settings of a network interface:
1. Click the tools symbol in the toolbar.
2. Click the Network > Interfaces tabs.
3. Use Interface A or Interface B paragraphs to enter the following data:
IMPORTANT: Please mind the separate instructions regarding Configuring the
network settings on page 11.
IMPORTANT: It is not possible to operate both network interfaces within one subnet.
NOTE: According to RFC 3330, the Link Local address space 169.254.0.0/16 is
reserved for the internal communication between devices. An IP address of this
address space cannot be assigned.
Operational
mode:
Use the pull-down menu to select the operating mode of
Interface A or Interface B :
 Off: switches off network interface.
 Static: uses static settings.
 DHCP: obtains the settings from a DHCP server.
 Link aggregation active: This interface was added to a group
of network interfaces.
Use the »Link aggregation« tab to configure the network interfaces.
IP address: Only if the Static operating mode is selected: Enter the inter-
face IP address.