Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 171)

CrossDisplay Switching
G&D DVICenter · 169
Workspace
The right column (in the following called workspace) shows monitors of modules you
can switch by using CrossDisplay Switching.
Monitors are displayed as rectangles. Both the module name and the assigned
Tradeswitch key are displayed in the rectangle. You can use the handles to change
the rectangles’ height and width.
Figure 3 shows the handles as small black boxes framing
User module 1 .
Click (left arrow) to remove the selected rectangle from the workspace.
The workspace’s standard zoom level shows 8 × 8 units. However, you can adjust
the size of the workspace:

Press (zoom in) or the hotkey Ctrl+[+] to maximize the workspace. The maxi-
mum zoom level shows a workspace of 4 × 4 units.
 Press (zoom out) or the hotkey Ctrl+[-] to minimize the workspace. In the mini-
mum zoom level, the workspace is displayed as 32 × 32 units (default setting).
 You can reset the standard zoom level by pressing Ctrl+0 .
Status bar
The status bar at the lower edge of the window informs you about the following fea-
tures of the selected module:
 Name of user module or target module
 Assigned Tradeswitch key
 Master status of user modules
ADVICE: You can also drag and drop the modules by mouse or use the module’s
context menu to remove the rectangle from the workspace.
NOTE: The maximum size of the workspace is adjusted dynamically if you drag an
element beyond the available workspace.
You can increase the original size of 32 × 32 units as required.
NOTE: The master user module of the Tradeswitch console displays Yes . Every
other module displays No .