Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 122)

Automatically or manually switching the target modules
120 · G&D DVICenter
Automatically or manually switching
the target modules
Auto scanning all target modules (Autoscan)
The Autoscan function successively accesses all target modules that are mentioned in
the active scancode set and available to the user.
The Scantime setting (see page 120) enables you to define how long a target module
is to be accessed.
When accessing the target modules, the workplace name, the name of the currently
accessed target module, and a note regarding the Autoscan function are displayed.
Applying the Autoscan function
Configuring the scantime of the Autoscan function
By default, a target module is accessed for five seconds. After that, the target module
is disconnected and the next target module is accessed.
Select a time span between 1 and 99 seconds to define how long the target module is
to be accessed.
How to change the scantime:
1. Click on the User area > User entries in the tree view.
2. Right-click on the user account to be configured and click Configuration in the con-
text menu.
3. Click the Matrix systems > Personal Profile > Matrix switch tabs.
4. Use the Scantime entry to enter a time span between 1 and 99 seconds.
5. Click OK to save your settings.
NOTE: If the Autoscan function is active, the keyboard and mouse inputs are trans-
mitted to the currently accessed target module.
During your inputs, the Autoscan function stops and continues after you finished
your inputs.
Requirements for using this function:
 Creating a scanmode set (see page 123)
 Assigning a scanmode set to a user account (see page 125)