Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 149)

Replicating the database of a KVM matrix switch
G&D DVICenter · 147
Replicating the database of a KVM matrix
switch
Certain target modules can be connected to two separate KVM matrix switches.
In such cases it is useful to replicate the database of a matrix switch (Master) to the
other matrix switch (Destination). The following paragraphs list the configuration set-
tings of the master matrix switch that can be replicated to one or several destinations.
Overview of the data to be replicated
The web application defines the scope of data to be replicated. In the following, the
data to be replicated are listed according to topic.
Matrix switch
The following configuration settings are copied from the master device to a destination:
Tradeswitch function
The following configuration settings are copied if the tradeswitch function is enabled
on both the master device and the destination:
Target modules
The following data and settings of target modules are transmitted for all target mod-
ules that are connected to both master device and destination:
 Hotkey modifier  Hotkey
 Select key modifier  Permitted select keys
 Multiuser display  Forwarding of target names
 RS232 mode  RS232 bit rate
 Tradeswitch key modifier  Permitted tradeswitch keys
 Settings for CrossDisplay Switching
 Name  Comment
 Configuration settings
NOTE: If the destination already contains a local target with the same name, it is
renamed to »Name (local)«.