Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 166)

Tradeswitch function (option)
164 · G&D DVICenter
Enhanced functions
Enabling or disabling the Tradeswitching information display
If you purchased the Tradeswitch function, the messages »Forwarding to...« (at the master
workplace) or »Forwarded« (at the target workplace) can be displayed at the monitor.
How to enable or disable the Tradeswitching information display:
1. In the directory tree, click KVM Matrix systems > [Name] > Consoles .
2. Right-click the user module you want to configure. Now click the Configuration
entry on the context menu.
3. Click the General tab.
4. Use the Display Tradeswitching entry to select between the following options:
5. Click OK to save your changes.
Starting user modules without keyboard
If no keyboard is connected to a user module, the user receives an according message
directly after the user module has been switched on. The booting process is cancelled.
How to enable or disable the booting of user modules without a keyboard:
1. In the directory tree, click KVM Matrix systems > [Name] > Consoles .
A list of all workplaces is displayed.
2. Right-click the user module you want to configure. Now click Configuration on the
context menu.
3. Click the General tab.
4. Use the Keyboard required entry to select between the following options:
5. Click OK to save your changes.
Yes: Enables information display
No: Disables information display
NOTE: Use the Keyboard required setting to boot the user module.
Yes: User module only boots with connected keyboard
No: User module boots without keyboard