Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 168)

CrossDisplay Switching
166 · G&D DVICenter
Requirements for »CrossDisplay Switching«
Using CrossDisplay Switching requires the following:
 Enabled premium Tradeswitch function (see page 159).
 Established and configured Tradeswitch configuration (Workplace) (see page 159).
 Enabled CrossDisplay Switching (see page 170).
 Order of console monitors saved in the web application (see page 171).
Order and proportions of monitors
Figure 1 shows three monitors placed in a row.
In addition to monitors placed next to each other, any combinations are supported.
Even the monitors’ proportions can vary. The following table shows some examples
and describes special features.
IMPORTANT: Only USB target modules connected to the target computer by USB
cables support CrossDisplay Switching.
NOTE: In the web application you can save the order and proportions of your
monitors according to how they are placed on the desk.
In addition to switching to a monitor
placed on the left or the right side of
the active monitor, you can also switch
to monitors placed above or below the
active monitor:
Move the cursor to one of the edges
between monitors 1 and 3 or 2 and 4 to
switch from an upper monitor to a
lower monitor (or vice versa).
If the monitors are placed as shown on
the left, it is important to mind the exact
vertical cursor position when reaching
the lower edge of Monitor 1 :
 In the first third you can switch to
monitor 2.
 In the second third you can switch to
monitor 3.
 In the last third you can switch to
monitor 4.