Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 176)

CrossDisplay Switching
174 · G&D DVICenter
a. If you want to apply the system settings of the mouse speed to the target mod-
ule, enable the System option under Mouse speed .
b. If you want to set an individual mouse speed, disable the System option and set
the controller to the desired value.
4. Click OK .
Correcting horizontal and vertical mouse speed
With active CrossDisplay Switching, the mouse speed is not controlled by the operating
system of the target computer but by the matrix switch.
If the cursor speed changes between horizontal and vertical mouse movements, the
monitor resolution could not be auto detected.
In such cases, a resolution of 1680 × 1050 pixels applies. If the monitor’s resolution
differs from this resolution, the mouse moves as described above.
In this case, you can adjust the monitor resolution manually.
How to adjust the CrossDisplay resolution of a target module:
1. In the directory tree, click KVM matrix systems > [Name] > Target modules .
2. In the display range, right-click the target module you want to configure and
click Configuration on the context menu.
3. Disable the Auto option under CrossDisplay resolution .
4. Enter the vertical and horizontal resolution in the input boxes.
5. Click OK .