Compatibility mode, Through, Ports – Guntermann & Drunck DVICenter DP16 Config Panel User Manual
Page 20: Are pre-configured to connect a sub matrix switch, Or as, Configure at least one port as, And one port as
Getting started
18 · G&D DVICenter
In the default settings, ports
1
through
8
are pre-configured to connect a superior
matrix switch (
Up mode
).
Ports
9
through
32
are pre-configured to connect a sub matrix switch (
Down mode
).
To change the port assignment mind the following instructions:
Configure all 32 ports either as
Up port
or as
Down port
.
Configure at least one port as
Up port
and one port as
Down port
.
Compatibility mode
Figure 2: Port settings in default mode
ADVICE:
To facilitate the installation of the KVM switch, you can switch the port
LEDs to the port mode (see page 20).
NOTE:
Up to version 1.10 of the web application, the
CON
or
CPU mode
of ports
could be manually assigned by the user. After a firmware update to the current
version, the web application of a configured matrix switch activates the Compatibil-
ity mode and applies the user’s previous manual configuration.
ADVICE:
Click on
Compatibility mode
to switch between Standard mode and Compatibility
mode.
UP
D
G &
UP
D
G &
UP
D
G &
UP
D
G &
UP
D
G &
UP
D
G &
UP
D
G &
UP
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &
DOWN
D
G &