Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 189)

Connecting analogue matrix switches (Bridging)
G&D DVICenter · 187
Connecting analogue matrix switches
(Bridging)
As of firmware version 1.7.000 of the digital matrix switch DVICenter , you can inte-
grate analogue matrix switches of the CATCenter NEO series into the KVM matrix sys-
tem.
Operation
Using a VGA-CPU target module, the digital matrix switch DVICenter establishes a con-
nection to one of the UCON user modules connected to the analogue matrix switch
CATCenter NEO .
The target module VGA-CPU is directly connected to the signal line of the user module
UCON . The matrix switches communicate over a TCP/IP connection.
The digital matrix switch can use every established Bridge line to switch to any target
module of the analogue matrix switch.
The target modules of the analogue matrix switch are listed in the OSD and in the
web application of the digital matrix switch. Here, they can be configured (see
page 84 ff.) and grouped (see page 142 ff.).
Figure 1: Connection of a digital and an analogue matrix switch
EXAMPLE: A user uses the OSD of the digital matrix switch DVICenter to access the
target NEO-Target connected to the analogue matrix switch CATCenter NEO.
 Over the TCP/IP connection, the digital matrix switch DVICenter transmits the
switching command to the analogue matrix switch NEO .
 The digital matrix switch DVICenter switches the user to the target module VGA-
CPU of the Bridge line.
 The analogue matrix switch NEO switches the computer ti the user module UCON
of the Bridge line.
DVICenter
CATCenter
NEO
VGA-CPU UCON