Messages – Guntermann & Drunck DVICenter DP16 Config Panel User Manual
Page 177
![background image](https://www.manualsdir.com/files/788354/content/doc177.png)
CrossDisplay Switching
G&D DVICenter · 175
Messages
In some cases CrossDisplay Switching cannot be used.
In such cases, a message is displayed. The messages have the following meaning:
Message
Meaning
No CDS: Console multiaccess mode
The user module is included in several Workplaces
(Tradeswitch configurations).
Two or more input devices from different Workplaces
access the user module.
No CDS: Console not found
The user module does not (no longer) exist in the matrix
switch database.
No CDS: Disabled
CrossDisplay Switching is disabled for the currently
accessed target module.
Check the settings in the target module and the settings
for the entire system (see page 170 ff.).
No CDS: No TradeSwitch modifier
The Tradeswitch key modifier is not defined.
Enable a modifier as described on page 160.
No CDS: Target not found
The target module does not (or no longer) exist in the
matrix switch database.
No CDS: Target not supported
The target module or the installed firmware does not sup-
port CrossDisplay Switching.
Contact our support team for more information.
No CDS: USB missing on target
Only USB target modules connected to the target com-
puter by USB cables support CrossDisplay Switching.
Check the variant of the target module and the computer’s
connection to the module.
No CDS: View only mode
The user has restricted rights on the accessed computer.
The user has »View only« rights and can make no inputs.
CrossDisplay Switching is not possible.