Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 132)

Configuring the On-Screen Display (OSD)
130 · G&D DVICenter
Defining a standard view filter
After the user login, the Select menu is displayed. The default setting of the Select
menu displays all target modules. By applying the view filter, the display of the tar-
get modules can be filtered.
If you want to activate a certain view filter directly after accessing the Select menu,
you can configure the user account accordingly.
How to select a standard view filter for the Select menu:
1. In the directory tree, click on
User area > User .
2. Right-click the user account you want to edit and click on Configuration in the con-
text menu.
3. Click on Matrix systems > Personal Profile > Matrix switch .
4. Under Def. view filter, you can select between the following options:
5. Click OK to save your settings.
Selecting the mode for OSD synchronisation
If both the synchronisation signal and the colour information are transmitted through
one cable, the on-screen display is displayed in a slightly deviating, palish colour.
In this case you can select several synchronisation modes for the graphics signal of
the target computer.
NOTE: The preset view filter is applied directly after your login at the matrix system.
By applying the view filter, you can change the default and therefore activate
another filter.
ALL: Displays all target modules
LAST: The view filter that was used by the last user is applied when
the Select menu is called in the OSD.
View filter
name:
The selected view filter is applied if the Select menu is called in
the OSD.
IMPORTANT: When the LAST option has been selected and the user account is
shared by two persons at the same time, the view filter of the last active person is
stored.