Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 186)

CDS multihead groups
184 · G&D DVICenter
Member configuration
Saving order and resolutions of display ranges
Arrange the display ranges of the graphics cards installed in multihead computers in the
same way as they are displayed in the computer’s graphics configuration.
How to save the order and resolution of display ranges:
1. In the directory tree, click on
KVM matrix systems > CDS multihead groups .
2. Right-click the matrix switch, and click Configuration on the context menu.
3. Click on the Member configuration tab.
4. Carry out one or multiple operations described on the following page until the
the arrangement in the workplace complies with the computer’s graphics set-
tings.
5. Click OK .
How to add a display range within the workspace:
1. Mark a target module on the left side.
IMPORTANT: Make sure to fulfil the requirements regarding the configuration and
use of CDS multihead groups listed on page 180 .
IMPORTANT: Plan the configuration and set-up of CDS multihead groups carefully.
Incomplete or incorrect configuration settings can be the reason why you can not
use CDS to switch to the desired computer.
IMPORTANT: You can arrange the individual display ranges into horizontal or ver-
tical order or in blocks. Blocks must be put together into complete quadrangles. L-
shaped arrangements are not supported.
NOTE: The different elements of this tab are described on page 181.
ADVICE: Press Shift or Ctrl to select multiple modules at the same time.