Including multi-head monitors – Guntermann & Drunck DVICenter DP16 Config Panel User Manual
Page 169
CrossDisplay Switching
G&D DVICenter · 167
Including multi-head monitors
Matrix systems support computers whose desktop is displayed on multiple monitors
(see page 142 ff.). These computers are called multi-head computers.
By default, the monitor of a multi-head computer is displayed in the standard moni-
tor size. However, you can change the size (monitor 2 in the example below) to the
proportions of the other monitors:
If the monitors are placed as shown on
the left, it is important to mind the exact
horizontal cursor position when reaching
the left or right edge of
Monitor 3
:
In the upper half you can switch to
monitors 1 or 4.
In the lower half you can switch to
monitors 2 or 5.
Figure 2: Two monitors of a multi-head computer between other monitors
NOTE:
Install the driverr
G&D CDS Multi-Monitor Support
if you cannot move the cursor
across both monitors of a multi-head computer.
You can download the driver from
www.gdsys.de
under
Downloads > Drivers
.