Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 191)

Connecting analogue matrix switches (Bridging)
G&D DVICenter · 189
3. Click the Bridge mode tab.
4. Enter the following data:
5. Click OK to save your settings. Now the Bridge mode is enabled.
Disabling the Bridge mode of a target module
How to disable the Bridge mode of a target module:
1. In the directory tree, click
KVM matrix system > [Name] > Bridge module .
2. Right-click the Bridge module ( VGA-CPU ) you want to configure and click Configu-
ration on the context menu.
3. Click the Bridge mode tab.
4. Click Reset to reset the Bridge mode settings.
5. Click OK to save your settings. Now, the Bridge mode is disabled..
UCON-ID: Enter the device ID of the user module used for the Bridge
line.
The web application of the analogue matrix switch lists the
device ID under KVM matrix system > [Name] > User modules .
NEO IP address: Enter the IP address of the analogue matrix switch CATCenter NEO .
NOTE: After the Bridge mode of a target module is disabled, the module is listed
in the directory tree under KVM matrix system > [Name] > Target modules .