Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 123)

Automatically or manually switching the target modules
G&D DVICenter · 121
Auto scanning all active target modules (Autoskip)
The Autoskip function successively accesses any target module that is included into
the active scancode set and available to the user.
The connected computer must be active to carry out this function.
The Scantime setting (see page 120) enables you to define how long each target mod-
ule is to be accessed.
When accessing the target modules, the workplace name, the name of the currently
accessed target module, and a note regarding the Autoscan function are displayed.
Applying the Autoskip function
Configuring the scantime of the Autoskip function
By default, each target module is accessed for five seconds. After that, the target
module gets disconnected and the next target module is accessed.
Select a time span between 1 and 99 seconds in order to define how long the target
module is to be accessed.
How to change the scantime:
1. Click on the User area > User entries in the tree view.
2. Right-click on the user account to be configured and click Configuration in the con-
text menu.
3. Click the Matrix systems > Personal Profile > Matrix switch tabs.
4. Use the Scantime entry to enter a duration between 1 and 99 seconds.
5. Click OK to save your settings.
NOTE: If the Autoskip function is activated, all keyboard and mouse inputs are
transmitted to the currently accessed target module.
The Autoskip function stops during the user’s imputs and continues after all inputs
are finished.
Requirements for using this function:
 Creating a scanmode set (see page 123)
 Assigning a scanmode set to a user account (see page 125)