Pilz PNOZ mm0p 24VDC - Manual (Page 99)

Modbus/TCP
Operating Manual PNOZmulti communication interfaces
1001154-EN-13
99
Virtual outputs
The table below describes the Modbus/TCP data areas that contain the state of the virtual
outputs on the PNOZmulti.
Relevant areas for the data are defined in the Modbus/TCP data areas Discrete Inputs (1x)
and Input Register (3x). Read access is available to these data areas.
Register
(3x) Descrete Input
(1x)
Content High Byte Low Byte
512 8207...8192 State of the outputs
0...15 o15…o8 o7…o0
513 8223...8208 State of the outputs
16...31 o31…o24 o23…o16
514 8239...8224 State of the outputs
32...47 o47…o40 o39…o32
515 8255...8240 State of the outputs
48...63 o63…o56 o55…o48
516 8271...8256 State of the outputs
64...79 o79…o72 o71…o64
517 8287...8272 State of the outputs
80...95 o95…o88 o87…o80
518 8303...8288 State of the outputs
96...111 o111…o104 o103…o96
519 8319...8304 State of the outputs
112...127 o127…o120 o119…o112
LEDs
The table below describes the Modbus/TCP data areas that contain the LED statuses.
Relevant areas for the data are defined in the Modbus/TCP data areas Discrete Inputs (1x)
and Input Register (3x). Read access is available to these data areas.
Register
(3x) Discrete Input
(1x)
Content High Byte Low Byte
520 8335...8320 8 Bit LED status;
8 Bit reserved Reserved PNOZmulti
LEDs
521…783 Reserved
Bit 0 = 1: LED OFAULT illuminates or flashes
Bit 1 = 1: LED IFAULT illuminates or flashes
Bit 2 = 1: LED FAULT illuminates or flashes
Bit 3 = 1: LED DIAG illuminates or flashes
Bit 4 = 1: LED RUN illuminates
Bit 5: Reserved
Bit 6: Reserved
Bit 7: Reserved
6.4.4.3
6.4.4.4