Pilz PNOZ mm0p 24VDC - Manual (Page 68)

Fieldbus modules
Operating Manual PNOZmulti communication interfaces
1001154-EN-13
68
Diagnostic data
These bytes contain the diagnostic data
Byte Diag_Bit Content
2112 000 RUN, base unit is in RUN condition
001 STOP, base unit is in STOP condition
002 Base unit was stopped by the Configurator
003 Start failed. External cause
004 External fault
005 Internal fault
006 External fault at the inputs
007 Internal fault at the inputs
2113 008 External fault at the outputs
009 Internal fault at the outputs
010 Fault on 1st expansion module, left
011 Fault on 2nd expansion module, left
012 Fault on 3rd expansion module, left
013 Fault on 4th expansion module, left
014 Fault on 5th expansion module, left
015 Fault on 6th expansion module, left
2114 016 Fault on the base unit
017 Fault on the 1st expansion module, right
018 Fault on the 2nd expansion module, right
019 Fault on the 3rd expansion module, right
020 Fault on the 4th expansion module, right
021 Fault on the 5th expansion module, right
022 Fault on the 6th expansion module, right
023 Fault on the 7th expansion module, right
2115 024 Fault on the 8th expansion module, right
025 Fault on the link module
026 Fault on the analogue input module
027 Reserved
028 Reserved
029 Reserved
030 Reserved
031 Internal fault on the left-hand expansion module
4.5.3.7