Pilz PNOZ mm0p 24VDC - Manual (Page 52)

Fieldbus modules
Operating Manual PNOZmulti communication interfaces
1001154-EN-13
52
Module features
} Can be configured in the PNOZmulti Configurator
} Network protocols: Ethernet IP, Modbus TCP
} Status indicators for communication and for errors
} Transmission rate 10 MBit/s (10BaseT) and 100 MBit/s (100BaseTX), full and half du-
plex
} Setting of the IP address using DIP switches on the front panel
Assigning the IP address to your PC
} Please refer to the operating instructions for your operating system for the procedure.
} Set the IP address, e.g. 192.168.0.1, with subnet mask 255.255.255.0.
Setting the IP address of the expansion module
The IP address of the PNOZ mc8p is set using DIP switches on the front panel.
Please note: Only set the IP address when the supply voltage is switched off.
The first three bytes of the IP address are:
} IP address: 192.168.0
} Subnet mask: 255.255.255.0
The last byte is configured using the DIP switches.
Value range: 1 ... 255
Note: The IP address of the PNOZ mc8p should not be the same as the IP address for the
PC.
Example: DIP switch: 00010100 (20 decimal)
1 2 3 4 5 6 8 7
ON
(MSB) (LSB)
IP address: 192.168.0.20
Once the IP address has been set via the DIP switches you can connect the supply voltage
to the base unit.
Changing IP settings
You can change the IP settings of the PNOZ mc8p after configuring the IP addresses of the
PC and PNOZ mc8p.
} Connect the PNOZ mc8p to the PC.
} Call up the following html page: http://192.168.0.20/config.htm.
} Configure the settings for the PNOZ mc8p.
Example: IP address: 172.16.216.139
Subnet mask: 255.255.0.0
Gateway address:--
DNS1 address:--
DNS1 address:--
4.4.3
4.4.4
4.4.5
4.4.6