Pilz PNOZ mm0p 24VDC - Manual (Page 133)

Diagnostic word
Operating Manual PNOZmulti communication interfaces
1001154-EN-13
133
} Two-hand pushbuttons
Bit Message Comment
1 Two-hand button must be operated. Switches are in their start position.
4 Pushbutton 1 or 2 was operated too late. Simultaneity was exceeded.
5 Pushbutton 1 or 2 was not operated. One of the pushbuttons was operated too
late or was not operated at all. Or one of the
pushbuttons was operated and then re-
leased.
6 Two-hand button is deactivated. Deactivation input is configured and =1
8 Error in the test pulse wiring.
} Operating mode selector switch
Bit Message Comment
5 The input signals at the operating mode selector switch
are faulty
No input is “1”.
8 Error in the test pulse wiring.
} Analogue input module
Bit Message Comment
2 Analogue input module is ready for reset Manual or monitored reset was configured.
The reset button has not yet been operated.
3 Tolerance between input I0 and I1 has been exceeded The configured permitted deviation between
the measured values for i0 and i1 has been
exceeded.
4 Range limit R1 has been violated. The value is above or below the configured
range limit.
5 Range limit R2 has been violated.
6 Range limit R3 has been violated.
7 Range limit R4 has been violated.
8 Threshold value monitoring for the threshold L1 has
been activated (Status =1).
9 Threshold value monitoring for the threshold L2 has
been activated (Status =1).
10 Threshold value monitoring for the threshold L3 has
been activated (Status =1).
11 Threshold value monitoring for the threshold L4 has
been activated (Status =1).
12 Threshold value monitoring for the threshold L5 has
been activated (Status =1).
13 Threshold value monitoring for the threshold L6 has
been activated (Status =1).