Pilz PNOZ mm0p 24VDC - Manual (Page 47)

Fieldbus modules
Operating Manual PNOZmulti communication interfaces
1001154-EN-13
47
61 O8 ... O15 8th expansion
module, right
Sub-Index 54 ... 61:
PNOZ mc1p
Sub-Index 38 ... 45:
A7
A6 A5 A4 A3 A2 A1 A0
Sub-Index 54 ... 61:
A15
A14 A13 A12 A11 A10 A9 A8
If an output has a high signal, the corresponding Bit will contain
"1"; if the output is open (low signal), the Bit will contain "0".
INFORMATION:
On the base units PNOZmulti Mini, the status of the configurable
inputs/outputs is only displayed if they are configured as outputs
in the PNOZmulti Configurator.
Assignment of Bytes on the
base units PNOZmulti Mini:
Sub-Index 33:
0
0 0 0 IM3 IM2 IM1 IM0
Sub-Index 35:
T3M23 T2M22 T1M21 T0;20 IM19
IM18 IM17 IM16
62 ... 64 Reserved
65 RUN Depending on the LED status, the following Hex code will be in
Sub-Index 65 ... 77:
00 hex: LED off
FF hex: LED on
30 hex: LED flashes
66 DIAG
67 FAULT
68 IFAULT
69 OFAULT
70 FAULT 1: Expansion mod-
ule, right
71 FAULT 2: Expansion mod-
ule, right
72 FAULT 3: Expansion mod-
ule, right
73 FAULT 4: Expansion mod-
ule, right
74 FAULT 5: Expansion mod-
ule, right
75 FAULT 6: Expansion mod-
ule, right
76 FAULT 7: Expansion mod-
ule, right
77 FAULT 8: Expansion mod-
ule, right