Pilz PNOZ mm0p 24VDC - Manual (Page 55)

Fieldbus modules
Operating Manual PNOZmulti communication interfaces
1001154-EN-13
55
} Save the file ip_access.cfg on your PC.
} Download the file to the PNOZ mc8p.
} Restart the PNOZmulti.
Input and output data
The data is structured as follows:
Input area
The inputs are defined in the master and transferred to the PNOZmulti. Each input has a
number, e.g. input bit 4 of byte 1 has the number i12.
Output area
The outputs are defined in the PNOZmulti Configurator. Each output that is used is given a
number there, e.g. o0, o5... .
The status of output o0 is stored in bit 0 of byte 0; the status of output o5 is stored in bit 5 of
byte 0 etc.
Output area only: Byte 3
} Bits 0 … 4: Status of LEDs on the PNOZmulti
– Bit 0: OFAULT
– Bit 1: IFAULT
– Bit 2: FAULT
– Bit 3: DIAG
– Bit 4: RUN
} Bit 5: Data is being exchanged.
Information
Please refer to the chapter entitled "Basics", under
Input data (to the PNOZ-
multi) [ 13] / Output data (from the PNOZmulti) [ 13]
Assigning the inputs/outputs in the PNOZmulti Configurator to the Ethernet IP/
Modbus TCP input/output data
Multi Configurator inputs I0 ... I7 I8 ... I15 I16 ... I23
Ethernet IP or Modbus TCP input data Byte 0: Bit 0
... 7
Byte 1 :Bit 0
... 7
Byte 2 :Bit 0
... 7
PNOZmulti Configurator outputs O0 ... O7 O8 ... O15 O16 ... O23
Ethernet IP or Modbus TCP output data Byte 0 : Bit 0
... 7
Byte 1 :Bit 0
... 7
Byte 2 :Bit 0
... 7
4.4.10
4.4.10.1