Pilz PNOZ mm0p 24VDC - Manual (Page 138)

Diagnostic word
Operating Manual PNOZmulti communication interfaces
1001154-EN-13
138
} Press element: Monitoring of rotary cam arrangement
Bit Message Comment
2 Monitoring of the rotary cam arrangement is ready for
reset.
1/0 pulse edge at reset input parameter
3 Overrun was exceeded.
8 The run-up cam failed to switch off when the overrun
cam was switched off.
NL: Overrun cam, HL: Run-up cam
Plausibility error 1: NL = 1/0 pulse edge and
HL = 1
9 The run-up cam failed to switch on when the overrun
cam was switched on.
Plausibility error 2: NL = 0/1 pulse edge and
HL = 0
10 The overrun cam failed to switch off when the run-up
cam was switched on.
Plausibility error 3: HL = 0/1 pulse edge and
NL = 1
10 The overrun cam failed to switch on when the run-up
cam was switched off.
Plausibility error 4: HL = 1/0 pulse edge and
NL = 0
} Press element: Set-up mode
Bit/
DW Message Comment
DW =
0
“Set-up” mode has been enabled
Bit 0 "Set-up" mode is not active. Enable has not been triggered, input param-
eter MODE = 0
Bit 2 Press is ready for reset. 1/0 pulse edge at reset input parameter
Bit 8 Cannot switch on because the start enable (“EN2”)
has not been triggered.
No enable because start enable EN2 = 0
Bit 9 Cannot switch on because the static enable (“EN1”)
has not been triggered.
No enable because static enable EN1 = 0
Bit 11 Press was stopped because the static enable (“EN1”)
is missing.
No enable because static enable EN1 = 0
during operation
} Press element: Single-stroke
Bit/
DW Message Comment
DW =
0
“Single-stroke” mode has been enabled
Bit 0 "Single stroke" mode is not active. Enable has not been triggered, input param-
eter MODE = 0
Bit 2 Press is ready for reset. 1/0 pulse edge at Reset input parameter
Bit 8 Cannot switch on because the start enable (“EN2”)
has not been triggered.
No enable because start enable EN2 = 0
Bit 9 Cannot switch on because the static enable (“EN1”)
has not been triggered.
No enable because static enable EN1 = 0