Pilz PNOZ mm0p 24VDC - Manual (Page 139)

Diagnostic word
Operating Manual PNOZmulti communication interfaces
1001154-EN-13
139
Bit/
DW Message Comment
Bit 10 Cannot switch on because the safety enable (“EN3”)
has not been triggered.
No enable because there is no safety ena-
ble EN3 = 0
Bit 11 Press was stopped because the static enable (“EN1”)
is missing.
No enable because static enable EN1 = 0
during operation
Bit 12 Safety enable (“EN3”) is missing. No enable because safety enable EN3 = 0
during operation
} Press element: Automatic mode
Bit/
DW Message Comment
DW =
0
“Automatic” mode has been enabled
Bit 0 "Automatic" mode is not active. Enable has not been triggered, input param-
eter MODE = 0
Bit 2 Press is ready for reset. 1/0 pulse edge at Reset input parameter
Bit 8 Cannot switch on because the start enable (“EN2”)
has not been triggered.
No enable because start enable EN2 = 0
Bit 9 Cannot switch on because the static enable (“EN1”)
has not been triggered.
No enable because static enable EN1 = 0
Bit 11 Press was stopped because the static enable (“EN1”)
is missing.
No enable because static enable EN1 = 0
during operation
Bit 13 Cannot switch on because the stop button has been
operated.
No enable because input parameter STOP
= 0
} Press element: Light curtain
Bit/
DW Message Comment
DW =
0
“Break” mode has been enabled
Bit 0 "Break" mode is inactive. Enable has not been triggered, input param-
eter MODE = 0
Bit 2 Light curtain is ready for break mode. Break mode is active, waiting for break
Bit 8 Enable must be performed. 1/0 pulse edge at Reset input parameter,
wait for reset
} Burner part 1
Bit Message Comment
2 Burner is ready for reset.
4 Stop (Signal=1 during start-up test)
5 Reset (Signal=1 during start-up test)
6 Safety chain 1 broken (CHA1)