Brother WP330MDS - Manual (Page 77)

Vertical Layout
Just as the word processor formats your lines to fit within the desired left and right
margins, it also automatically breaks your text up so that the maximum number of
lines fit onto the page with the desired line spacings, top and bottom margins, and
other formatting instructions that you specify.
Page Breaks
CODE ^
+
^ p m "f
P BREAK
The text is always automatically formatted so that a maximum number of lines can fit
on one page. Each time you want to start a new page, press CODE + P BREAK. A
page break symbol ^ will indicate that point, the cursor will move to the next line.
The page count (P indicator) is incremented and the line count (L indicator) restarts
from 1. If you change your mind, you can always erase this symbol (and eliminate the
page break) with BACKSPACE or CORRECT.
Line Spacing
T CODE ^
+
T®
"1
2
^
Pressing CODE + LINE cycles the L.SP indicator through the following values:
L.SP: 1,0 —> 1.5 2.0 —> 1.0
Line Spacing Number of Lines per inch
1.0 6 lines/inch
1.5 4 lines/inch
2.0 3 lines/inch
To keep the maximum amount of text in view at all times, the word processor uses
only single spacing on the screen. The number next to the L indicator, however,
reflects the actual line count on paper. If you are at the top of your text with the cursor
on line 1, for example, each time that you press the number that appears next to
the L indicator depends on the line spacing as follows:
Line Spacing Line Numbers
1.0 1,2, 3,4, 5, 6, 7,......
1.5 1,2 (2.5), 4, 5(5.5), 7, 8 (8.5), 10,....
2.0 1,3, 5, 7, 9, 11, 13,.....
67