Note, Changing correction tapes – Brother WP330MDS User Manual
Page 301
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Lift the acoustic cover.
NOTE:
It is not possible to move the carrier while the
acoustic cover is open. Close the acoustic
cover to re-position the carrier.
Grasp the cassette with both hands, raise the front
end and lift out.
NOTE:
The amount of ribbon remaining can be
checked thraugh the viewing hole on the right
side of the cassette.
Turn the feed knob on the left side of the new
cassette counterclockwise to take up any slack.
Align the arrow on the cassette with the center of
the cassette holder, slide the ribbon between the
guides, and use both hands to ease the cassette
into the holder.
Gently press down on the front of the cassette
until it clicks into place. Once again turn the teed
knob counterclockwise to take
up
any slack. Close
the acoustic cover.
Changing Correction Tapes
This word processor uses correction tape to correct printing errors. Two types of
corroction tapes are available, Brother Lift off tape model
#3010
(for use
with
th©
correctable film ribbon) and Brother Cover up tapes model #4010
(for
use with the
nylon ribbon).
291