Installing the crt stand, Installation, Warning – Brother WP330MDS User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the CRT Stand
Make sure thal Ihe CRT monilor in not conneuled to the AC outlet.
Carefully set the monitor face-down with the underside facing you,
NOTE:
The CRT stand is of the tilt/swivel type. Once the stand is installed, you can turn
the monitor laterally and vertically.
Installation
WARNING:
Please follow the steps below exactly. The base of the monitor can be
easily damaged If these directions are not followed.
1. Align the hooks on the stand with the matching slots in the base of the monitor.
2. Insert the hooks into the slots.
3. Slide the stand toward the front of the monitor until the latch clicks into the locked
position.