Brother WP330MDS - Manual (Page 298)

Troubleshooting Chart
Your word processor has been precision-manufactured to give you years of trouble-
free use. In the rare case that trouble does happen, you will probably be able to find
the solution in the table below. If you cannot, please do not attempt to repair the word
processor yourself. Instead, please contact your dealer.
Trouble Remedy
Nothing works after the
word processor has
been switched on.
Check that the power cord is plugged in.
Check that the acoustic cover is firmly closed.
Printout is impossible or
difficult to read. Check that the cassette daisy wheel is inserted
correctly.
Check that the cassette ribbon is positioned correctly.
Check that the installed daisy wheel matches the
selected KEYBOARD.
Correction on paper is
impossible. Check to see if the correction tape has run out and
replace it if necessary.
Check that the correction tape is installed properly.
Check that the correction tape you have purchased
corresponds to the cassette ribbon you are using.
All seems normal after
the word processor has
been switched on, but
nothing is displayed.
Adjust the brightness controller.
Printed and displayed
characters do not
match. Check that the installed daisy wheel matches the
selected KEYBOARD.
Check that the PAUSE FOR KEYBOARD CHANGE is
selected as NO on the Print Menu screen.
Diskette operation is
not possible. The diskette has been damaged, or a television set is
located too close to the drive. Try with another diskette
and/or move the word processor.
288