Note, Inserting paper, Paper support – Brother WP330MDS User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Turn on the power switch. The switch is located
on the left side toward the rear of the word
processor.
NOTE:
¡f the word processor does not respond,
check the power cord and then make sure
that the acoustic cover is securely latched.
Adjust the display brightness and contrast with
the controls located below the screen.
A good setting of the contrast allows you to
clearly distinguish bold characters from normal
characters on the screen.
NOTE:
When you switch the word processor off, wait at least 10 seconds before
switching it on again. Failure to wait 10 seconds may disrupt the start-up
sequence, resulting in faulty operation and possible hardware damage.
Inserting Paper
NOTE:
When using the word processor, you do not have to insert paper until you have
finished editing your document and are ready to print.
Paper Support
Lift the paper support.