Erasing one line, Notes, Relocation of the carrier – Brother WP330MDS User Manual

Page 120: Note, Manual corrections

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Erasing One Line

CODE

OUT^

LMEOUT

To erase an entire line, position the carrier to the right of the last character on the line

and press

CODE + LINE OUT.

The entire line is erased and you can retype.

NOTES:

Automatic erasing in progress can be stopped by pressing

CORRECT.

• Position the cursor to the space immediately to the right of the last character to be

erased while in centering, right margin flush, decimal tab, and LA. modes.

Congratulations on your purchase of this new word

Relocation of the Carrier

CODE

After a correction is made in the middle of the current line, pressing CODE + RELOC

moves the carrier to the position next to the last character.

NOTE:

Pressing CODE + RELOC moves the cursor to the space immediately to the right

of the last data while in the centering, right margin flush, decimal tab, and LA

modes.

Manual Corrections

When a correction is required above the current line, or if you have to reinsert the

paper, the memory correction does not work because the line memory is cleared each

time the paper is fed more than 1/12 inch.

NOTE:

This function cannot be executed while in the centering, right margin flush,

decimal tab or LA mode.

110