KEYENCE N-410 - Manual (Page 11)

9
How to Read this Manual
This section explains the layout of each page and the symbols and words used in the manual.
Page Layout
N-410
Se
ttin
gs
3
3-9
3-2 Sending and Receiving Settings
Sending settings to the N-410
The changed settings are forwarded to the N-410. Perform the following steps.
1
Press and hold the N-410 dipswitch for 8 seconds.
When the N-410 display shows "SO (50)", the communications state is as follows.
· Baud rate: 115200 bit/s · Stop bit: 1 bit
· Data bits: 8 bit · PLC link: None
· Parity: Even
2
Click the [Option] button on the AutoID Navigator, then make the settings for "COM port."
Make sure that the communication settings for the computer are compatible with those made in step
1. Click the [OK] button when settings are finished.
If "Multi-head mode" is selected, create the network using BL series devices
exclusively or using RF series devices exclusively.
Controlling Multi-head Mode
Sending commands to the N-410 and to BL/SR/RF series devices is the same as in multi-drop
link mode. Refer to
"4-1 Multi-drop Link Mode" (page 4-2) for more information.
Use normal (sequential) notification if you have both N-48/BL-U1 and NX-
50RS power supplies on the network.
Note
Caution
This is a note.
These notes indicate
operations or
procedure where
errors are common.
Make sure to read
these carefully.
This is a large
headline.
This is the chapter
title.
This is a reference to
a different page or
manual. Related
information can be
found in the location
indicated.
This is a medium
headline.
These are operating
instructions.
* This page was created for the purposes of this explanation and is thus
different from any actual page in this manual.
This is an index.
There is one for each
chapter.
This is a caution.
There is a risk of
damage or breakage
if the information in
these sections is not
heeded.