Canon 700 Series User Manual
Page 95
Using Speed Dialing
2-38
2
Using Speed Dialing
After five or ten seconds, the machine starts to send the document.
The transaction number and page numbers of the document are also displayed
during scanning.
If you are using Direct sending, you will see a series of brief, alternating
messages that tell you the machine is dialing, calling, then transmitting the
document. The number being dialed, name of the other party, and transaction
number of the document are also displayed.
NOTE
• To start scanning immediately, press
(Start). Otherwise, the machine waits five
to ten seconds before it starts to scan. This timeout feature can be turned ‘OFF’.
(See “TX (Send) Settings,” on p. 11-14.)
• The machine does not start dialing until you place your documents for sending. If
you enter the access code before you place your documents, the machine prompts
you to set your documents.
• If you press the access code key and enter an access code where no number has
been registered, the machine displays:
• If you want to cancel the transmission after you press the access code, press
(Stop).