Canon 700 Series - Manual (Page 18)

xvii
Users in Canada
Pre-installation Requirements for Canon Facsimile Equipment
A. Location
Supply a suitable table, cabinet, or desk for the machine. See Chapter 8,
" Appendix, " in the Reference Guide for specific dimensions and weight.
B. Order Information
1. Provide only a single line to touch-tone or rotary telephone set terminated with a
standard 4-pin modular telephone plug. (Touch-tone is recommended if
available in your area.)
2. Order an RJ11-C modular wall jack (USOC code), which should be installed by
the telephone company. If the RJ11-C wall jack is not present, telephone/fax
operation is not possible.
3. Order a normal business line from your telephone company's business
representative. The line should be a regular voice grade line or the equivalent.
Use one line per unit.
DDD (Direct Distance Dial) line
-or-
IDDD (International Direct Distance Dial) line if you communicate overseas
NOTE
Canon recommends an individual line following industry standards such as the 2500
(touch tone) or 500 (rotary/pulse dial) telephones. A dedicated extension off a PBX
without Camp On signals is also permitted with a fax machine. Key telephone systems
are not recommended because they send non-standard signals to individual telephones
for ringing, or send special codes which may cause a fax error.
C. Power Requirements
The power outlet should be a three-prong grounded receptacle (single or duplex).
It should be independent from copiers, heaters, air conditioners or any electrical
equipment that is thermostatically controlled. The rated value is 120 volts and 15
amperes. The RJ11-C modular jack should be relatively close to the power outlet to
facilitate installation.