Canon 700 Series - Manual (Page 279)

TX (Send) Settings 11-16
Summar
y
of Impor
tant Settings
11
An asterisk (*) indicates the default setting.
Setting Item Description
5. TIME OUT
ON*
OFF
Sets the interval between dialing (entering phone numbers) when
sending to more than one destination. (See “Sequential Broadcasting
to More Than One Location,” on p. 3-26.)
The machine scans the document in five or ten seconds after you
enter the telephone number.
Press [Start] to begin transmission. Otherwise, the machine returns to
the Standby mode.
6. STAMP ACTION
DIRECT & MEMORY TX*
DIRECT TX
Select whether to stamp every document you send, or only
documents sent using direct or memory sending. This setting is
available only after installing the optional Stamp Kit on your machine.
Stamps documents sent using direct and memory sending.
Stamps documents sent with direct sending only.
7. PIN CODE
OFF*
ON
NECESS. PIN CODE
OFF*
ON
PIN CODE BEF/AFT
BEFORE TEL NO.*
AFTER TEL NO.
Sets the PIN code feature for dialing through a PBX that requires PIN
codes. (See “Setting Up and Using PIN Codes,” on p. 10-6.)
Turns ‘OFF’ the PIN code feature.
Turns ‘ON’ the PIN code feature.
Forced PIN Code feature requires entering a PIN code for every
transaction.
Forced PIN code access is turned ‘OFF’. If you want to enter the PIN
code, press [Pin Code] before/after entering the telephone number.
The Forced PIN code access is turned ‘ON’. You must enter a PIN
code every time you dial.
Sets the PIN code to appear as a prefix or suffix of the telephone
number.
The PIN code appears as a prefix.
The PIN code appears as a suffix.