Canon 700 Series - Manual (Page 278)

TX (Send) Settings 11-15
Summar
y
of Impor
tant Settings
11
Setting Item Description
1. ECM TX
ON*
OFF
Turns ECM (Error Correction Mode) for transmission ‘OFF’ and ‘ON’.
This switch does not affect the settings for one-touch or coded speed
dialing. (See “Using Speed Dialing,” on p. 2-32.)
All transmissions are sent in the ECM if the other party’s fax machine
supports ECM.
ECM is turned ‘OFF’.
2. PAUSE TIME From 01 to 15SEC; 02SEC*
Sets the length of the pause entered between numbers when you
press [Redial/Pause]. (See “Adjusting the Length of a Pause,” on p.
2-3.)
3. AUTO REDIAL
ON*
1. REDIAL TIMES
2. REDIAL INTERVAL
3. TX ERROR RESEND
ON*
ALL PAGES
ERROR & 1ST
PAGE*
ERROR PAGE
OFF
OFF
Select whether to perform automatic redialing when the other line is
busy or there is no answer. (See “Setting Up Redialing,” on p. 3-23.)
Customize the redial operation.
From 01 to 10 TIMES; 02TIMES*
Even if the machine is set to redial several times, it only redials once if
there is no tone or ring back tone during the first attempt.
From 02 to 99 minutes; 02MIN.*
Selects whether to perform automatic redialing when a transmission
error occurs.
Customize the redial operation.
The machine redials the number and resends all of the failed pages of
the document.
The machine redials the number and resends the failed pages and
the first page of the document.
The machine redials the number and resends the failed pages only.
The machine does not perform automatic redial when a transmission
error occurs.
After the first attempt at dialing fails, redialing is not attempted.
4. ERASE FAILED TX
ON*
OFF
Select whether to delete the document of the failed transmission from
memory.
The document of the failed transmission is deleted from memory.
The document of the failed transmission remains in memory.