Canon 700 Series - Manual (Page 84)

Setting Up Group Dialing 2-27
2
Using Speed Dialing
NOTE
• If you want to use access code dialing, you have to register an access code (from
two to five digits) that represents the group dial you are registering.
• To use access code dialing, you need to set ACCESS CODE to ‘USE’ from the
SYSTEM SETTINGS menu, and set up the access code key. (See “Setting Up the
Access Code Key,” on p. 2-29.)
14
Enter an access code (from two to five digits) using the
numeric keys
➞ press [Set].
15
If you want to set the time for the group transmission, press
[
▼ ] or [ ▲ ] until <2.TX TIME SETTNG> appears
➞ press [Set].
If you do not want to perform this setting, proceed to step 19.
NOTE
• You can set up to five different times in a 24-hour period for sending.
• If you set the timer for a group dial, every document you send using this group dial
is sent at the same time everyday.
16
Press [ ▼ ] or [ ▲ ] to select a preset time number (1 to 5)
➞ press
[Set].
17
Enter the time in 24-hour notation using the numeric keys
(e.g., 1:00 p.m. as 13:00)
➞ press [Set].
The message appears on the LCD display for a few seconds.
➞
➞
➞
➞
4
1
7
5
2
8
6
3
9
0
Set
Set
Set
4
1
7
5
2
8
6
3
9
0
Set