Canon 700 Series User Manual

Page 93

Using Speed Dialing

2-36

Using Speed Dialing

NOTE
• You can adjust the resolution, contrast, and document type for scanning. (See

“Adjusting the Scan Settings,” on p. 3-4.)

• You can also specify a sender’s name with [TTI Selector]. (See “Selecting a

Sender’s Name,” on p. 3-6.)

Press the one-touch speed dialing key, or [Coded Dial]
followed by the three digit code, where the group of telephone
numbers you want to dial is registered.

After ten seconds, the machine starts to send the document.
The group dial name appears on the LCD display.

The transaction number and page numbers of the document are also displayed
during scanning.

NOTE
• To start scanning immediately, press

(Start). Otherwise, the machine waits ten

seconds before it starts to scan. This timeout feature can be turned ‘OFF’. (See “TX
(Send) Settings,” on p. 11-14.)

• The machine does not start dialing until you place your documents for sending. If

you try to specify destinations before you place your documents, the machine
prompts you to set your documents.

• If you press a one-touch speed dialing key, or

(Coded Dial) followed by a three

digit code, where no number has been registered, the machine displays:

• If you register fax numbers for group dialing, you can, as an option, set the time you

want your document to go out (up to five different times in a day).

• If you want to send your document at a preset time using group dialing, make sure

that no other preset time has been set by someone else for the group. (See
“Setting Up Group Dialing,” on p. 2-24.)

Coded Dial