Canon 700 Series - Manual (Page 119)

Redialing When the Line Is Busy 3-22
Sending Documents
3
Redialing When the Line Is Busy
If the other party’s line is busy or there is no answer, the machine waits two
minutes, then tries to dial the same number again. This feature is called “Automatic
Redialing.”
What Is Automatic Redialing?
After the initial dialing attempt, the machine waits two minutes, and tries to dial
again. If the second attempt fails, the machine waits for two more minutes, and
makes a third and final attempt to complete the call.
Auto Redial can be turned ‘ON’ and ‘OFF’. To perform this procedure, see “Setting
Up Redialing,” on p. 3-23.
The number of redialing attempts and the time interval between attempts can also
be set with the Auto Redial feature.
■ Messages Displayed When Redialing
While the machine is waiting to redial when using Direct TX, the following message is
displayed:
If all redialing attempts fail, the machine cancels the transaction, displays the following
message, and prints an Error TX report to remind you that the transmission did not
complete.
NOTE
• To cancel redialing, if you are using Direct Sending, press
(Stop). If you are using
Memory Sending, press [Delete File].
• To erase the document from memory, press [Delete File]. (See “Erasing a Document
from Memory,” on p. 9-22.)
• Even if the machine is set to redial several times, it redials only once if there is no dial
tone or ring back tone during the first attempt.