Canon 700 Series - Manual (Page 92)

Using Speed Dialing 2-35
2
Using Speed Dialing
NOTE
• To start scanning immediately, press
(Start). Otherwise, the machine waits five
or ten seconds before it starts to scan. This timeout feature can be turned ‘OFF’.
(See “TX (Send) Settings,” on p. 11-14.)
• The machine does not start dialing until you place your documents for sending. If
you dial the code before you place your documents, the machine prompts you to
set your documents.
• If you press
(Coded Dial) and enter a three digit code where no number has
been registered, the machine displays:
• If you register a number for coded speed dialing, you can, as an option, set the time
you want your document to go out (up to five different times in a day). (See “Setting
Up Coded Speed Dialing,” on p. 2-15.)
• If you want to send your document at a preset time using coded speed dialing,
make sure that no other preset time has been set by someone else for the code.
(See “Setting Up Coded Speed Dialing,” on p. 2-15.)
• If you want to cancel the transmission after you enter the coded speed dialing
code, press
(Stop).
Using Group Dialing
Follow this procedure to start a transmission and send a document to several
destinations with a one-touch or coded speed dialing number registered for group
dialing.
IMPORTANT
To use this feature, you must first register a group of telephone numbers for one-touch or
coded speed dialing. (See “Setting Up Group Dialing,” on p. 2-24.)
1
Place your documents on the machine.
For instructions explaining how to place your documents, see “Setting the
Document on the Machine,” on p. 3-3.