Canon REALiS X600 - Manual (Page 74)

User Command Specifications ９．Details of command ZCONTDRV
1 ZCONTDRV
ZCONTDRV
ZCONTDRV=
Zoom lens continuous control parameters
For details, refer to the RANGE command .
For all other responses, refer to "Error List."
This command is used to drive the zoom lens continuously.
(1)
（ Refer to the FCONTDRV command. ）
(2)
(3)
(4) ▼
a. REMOTE
b. LOCAL
c. POWER
d. ZCONTDRV=STOP
(5)
a. GET MODE e. GET PRODCODE
b. GET POWER f. GET ROMVER
c. GET ERR g. GET COMVER
d. GET LAMPCOUNTER
(6)
Control
> ZCONTDRV=TELE Control over the zooming to the telephoto end is started.
< I:OK
Range acquisition
> RANGE ZCONTDRV
< r:ZCONTDRV = I, STOP, WIDE, TELE
When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Supported Command States
OFF ON PM
－ － －
Ч ○ Ч
*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Commands
supported
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
It can be executed when the projector is in both the remote mode and power-on status at the same
time.
However, only the "STOP" parameter takes effect while the zoom lens is being driven, and a "busy"
response is given while the focus lens is being driven.
The following commands are acknowledged during zoom drive, and a response is returned while the
drive continues.
This command functions in the same way as when first the "ZOOM" button on the remote control or
main unit panel is pressed and then the "↑" or "↓" button is pressed.
The following commands are acknowledged during zoom drive, but zoom drive will also stop at the
same time.
In the case of any other commands, "i:BUSY (ZOOM)" is returned
unconditionally , and zoom drive
continues.
ＩＤ
Meaning
This stops the zooming.
This zooms to the wide-angle end.
This zooms to the telephoto end.
Zoom lens continuous drive control
Control Setting Reference Mode
Description
Response
Format
Parameter
STOP
WIDE
Commands
Function
Parameter
Zoom drive is started by specifying "TELE" or "WIDE." To stop the drive, add the "STOP"
parameter and send this command.
If no instruction was given to stop the drive, the drive stops at the drive direction end.
"i:OK" is returned when the drive was completed successfully.
TELE
Zoom drive stops when the "POWER" button on the remote control or main unit panel is pressed
during zoom drive.
"STOP," "WIDE" or "TELE" can be set for zoom lens
continuous drive.
Example
０１．００** ０１．０１** ０１．０１** ０１．０１**
SX50
○ ○
SX6 SX60 X600
Model Power supply Input Mode
Remote Local
× ○
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 － － － － － － － － － － －
SX6 ○ ○ ○ ○ ○ × ○ ○ ○ ○
SX60
X600
○
PAGE 66