Canon REALiS X600 - Manual (Page 155)

User Command Specifications 9．Details of command RANGE SAT
1 RANGE SAT
RANGE SAT
RANGE□SAT
r:SAT=N, ,
-1
A "busy" response is given while the zoom or focus lens is being driven.
With some input signals, it may not be possible to make this inquiry.
-2
> RANGE SAT
< r:SAT=N, -20, 20
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
Commands
supported
For all other responses, refer to "Error List."
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
(Refer to the ZCONTDRV command and FCONTDRV command.)
The color saturation can be set by the SAT command.
○ ○ ○ ○
01.00** 01.01** 01.01** 01.01**
Commands
Function
Format
Example
Description
Response
SX6
This inquires about the range within which the color saturation can be set.
Number
SX60 X600
Color saturation setting range request
Mode Control Setting Reference
Model Power Input Mode
None Remote Local
Remarks
D-RGB A-RGB1
SX50
A-RGB2 Comp Video S-Video D-Video SCART
SX50 Ч Ч Ч ○ ○ ○ – – Ч
SX6 Ч Ч Ч ○ ○ ○ Ч ○ ○
○ ○
SX60
Ч Ч
X600
PAGE 147