Canon REALiS X600 User Manual
Page 33
User Command Specifications
9. Details of command SEL
1
SEL
SEL
SEL=
Input signal selection parameter
Auto
This selects the input signal.
-1
A "busy" response is given while the zoom or focus lens is being driven.
Furthermore, it may not be possible to execute the command with some input signals.
-2
-3
Menu
[Display settings] - [Input signal selection] - [Auto]
[Display settings] - [Input signal selection] - [Auto]
-4
Setting
> SEL=AUTO
This sets the input signal selection to “AUTO”.
< i:OK
Reference
> GET SEL or ?SEL
This retrieves the input signal.
< g:SEL=575p
Acquisition of parameters which can be set
> RANGE SEL
< r:SEL=I, AUTO
Only "AUTO" can be set for the input signal selection.
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON
PM
Ч
○
Ч
Ч
○
Ч
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
Remarks
○
○
List of signals which can be detected
SX50
SX6
SX60
X600
01.00**
UNKNOWN
No-color, 1080p, and other signals
575i
Includes 288p (PAL non-interlaced signal)
480i
Includes 240p (NTSC non-interlaced signal)
575p
480p
The current input signal can be acquired using the applicable GET command.
720p
SX6
SX60
X600
SECAM
NTSC
1080i
Includes 540p (1080i non-interlaced signal)
1035i
Parameter
PAL
Includes PAL-M and PAL-N
Includes NTSC4.43
Description
Example
Commands
Function
Parameter
Response
Format
Meaning
Input signal selection
Parameter
Mode Control Setting
ID
Model
SX50
This command takes effect only with the "AUTO" parameter setting.
This command is the same as the menu functions in the table below.
01.01**
01.01**
01.01**
"i:OK" is returned if the parameter was set properly.
AUTO
Model
Power
Input
Mode
Remote Local
D-Video SCART
None
Remarks
D-RGB A-RGB1 A-RGB2 Comp
Video S-Video
SX50
Ч
Ч
Ч
○
○
○
–
–
Ч
○
Ч
SX6
Ч
Ч
Ч
Ч
○
Ч
○
○
○
Ч
SX60
X600
×
(Refer to the ZCONTDRV command and FCONTDRV command.)
For details, refer to the GET command.
Commands
supported
Reference
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
For all other responses, refer to "Error List."
○
○
PAGE 25