Canon REALiS X600 - Manual (Page 138)

User Command Specifications ９．Details of command RANGE AUTOSETEXE
1 RANGE AUTOSETEXE
RANGE AUTOSETEXE
RANGE□AUTOSETEXE
r:AUTOSETEXE=I, , , …,
For all other responses, refer to "Error List."
(1)
However, a "busy" response is given while the zoom or focus lens is being driven.
（ Refer to the ZCONTDRV command and FCONTDRV command. ）
(2) Auto setup can be controlled using the AUTOSETEXE command .
> RANGE AUTOSETEXE
< r:AUTOSETEXE=I, FOCUS, VKS, SCRN, INPUT
*Commands are indicated by ">", and responses are indicated by "<".
When a command is not supported, "e:000A INVALID_PARAMETER" is returned.
Supported Command States
OFF ON PM
－ － －
Ч ○ Ч
*If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
*When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Commands
supported
X600
SX60
○ ○ ○ × ○ ○ ○ ○ SX6 ○ ○ ○
- － － － SX50 － － －
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
Model Power supply Input Mode
Remote Local
× ○ ○ ○
０１．００** ０１．０１** ０１．０１** ０１．０１**
Commands
Function
Format
Example
Description
Response
X600
This command is used to inquire about the parameter options which enable auto setup to be set.
Setting Control
ＩＤ
SX50 SX6 SX60
Mode
Auto setup setting option request
－ － － -
This inquiry can be made when the projector is in both the remote mode and power-on status at
the same time.
Reference
PAGE 130