Canon REALiS X600 - Manual (Page 60)

User Command Specifications 9. Details of command IMAGEFLIP
1 IMAGEFLIP
IMAGEFLIP
IMAGEFLIP=：ＩＤ>
Image flip setting parameters
Flip horizontally
Flip vertically
Flip horizontally and vertically
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
Menu
[Display settings] - [Flip display]
[Display settings] - [Flip display]
-3
-4
Setting
> IMAGEFLIP=REAR
< i:OK
Reference
> GET IMAGEFLIP or ?IMAGEFLIP This retrieves the flip display state.
< g:IMAGEFLIP=REAR_CEILING
Acquisition of parameters which can be set
> RANGE IMAGEFLIP
<
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
Model
SX50
SX6
SX60
X600
○
SX50
r:IMAGEFLIP=I,NONE,CEILING,REAR,REAR_CEILING
Response "i:OK" is returned if the parameter was set properly.
This command is used to flip the screen display in various ways (vertically or horizontally).
CEILING
REAR
Rear ceiling
For details, refer to the RANGE command.
For all other responses, refer to "Error List."
REAR_CEILING
This command is the same as the menu functions in the table below.
The current flip display status can be acquired using the applicable GET command.
Description
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
When the display is flipped, the "keystone distortion" settings are initialized (set to HKS:0,
VKS:0).
Commands
Function
Parameter
Flip display
ID
Format
Mode Control Setting Reference
Example
01.00** 01.01** 01.01** 01.01**
SX6 SX60 X600
Model Power Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 ○ ○ ○ ○ ○ ○ – – ○ ○ ×
SX6 ○ ○ ○ ○ ○ × ○ ○ ○ ○
SX60
X600
○
Remarks
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
Meaning
None
Ceiling
Rear
Parameter
NONE
"NONE," "CEILING," "REAR" or "REAR
CEILING" can be selected as the flip
display setting.
Commands
supported
(Refer to the ZCONTDRV command and FCONTDRV command.)
For details, refer to the GET command.
This displays the image backwards (flip
vertically) on the screen.
○ ○ ○
PAGE 52