Canon REALiS X600 - Manual (Page 143)

User Command Specifications 9．Details of command RANGE HPIX/VPIX
1 RANGE HPIX/VPIX
RANGE HPIX/VPIX
Horizontal resolution setting range inquirVertical resolution setting range inquiry
RANGE□HPIX RANGE□VPIX
r:HPIX=N, ,
r:VPIX=N, ,
-1
A "busy" response is given while the zoom or focus lens is being driven.
With some input signals, it may not be possible to make this inquiry.
-2
> RANGE VPIX
< r:VPIX=N, 0, 1000
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
Setting
Commands
supported
X600
SX60
Ч Ч Ч Ч Ч Ч Ч ○ SX6 ○ ○ ○
– Ч ○ Ч SX50 ○ ○ ○
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
Model Power Input Mode
Remote Local
○ ○ ○ ○
01.01**
Example
Description
Response
01.01** 01.00** 01.01**
For all other responses, refer to "Error List."
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
(Refer to the ZCONTDRV command and FCONTDRV command.)
Commands
Function
Format
Horizontal/vertical resolution setting range request
Reference Mode Control
Ч Ч Ч –
Number
SX60 X600 SX50 SX6
These inquire about the ranges within which the horizontal and vertical resolutions can be set.
The horizontal and vertical resolutions can be set using the HPIX and VPIX commands,
respectively.
PAGE 135