Canon REALiS X600 - Manual (Page 88)

User Command Specifications 9．Details of command GET HPIX/VPIX
1 GET HPIX/VPIX
GET HPIX/VPIX
Horizontal resolution inquiry Vertical resolution inquiry
GET□HPIX GET□VPIX
?△HPIX ?△VPIX
g:HPIX=
g:VPIX=
For all other responses, refer to "Error List."
-1
A "busy" response is given while the zoom or focus lens is being driven.
（Refer to the ZCONTDRV command and FCONTDRV command.）
With some input signals, it may not be possible to make this inquiry.
-2
> GET VPIX or ? VPIX
< g:VPIX=684
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
–
These inquire about the current horizontal and vertical resolutions.
SX60 X600 SX50 SX6
○ ○ ○
Commands
Function
Format
Horizontal and vertical resolution inquiries
Mode Control Setting
Description
Response
01.01** 01.01**
Example
01.00** 01.01**
This inquiry can be made when the projector is in both the remote mode and power-on status at
the same time.
Commands
supported
Number
○
Model Power Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
Ч ○ Ч SX50 ○ ○ ○ Ч Ч Ч
Ч SX6 ○ ○ ○ Ч Ч ○
SX60
X600
The horizontal and vertical resolutions can be set using the HPIX and VPIX commands,
respectively.
Reference
Ч
–
Ч Ч Ч
PAGE 80