Canon REALiS X600 - Manual (Page 118)

User Command Specifications 9．Details of command GET LOGOPOS
1 GET LOGOPOS
GET LOGOPOS
GET□LOGOPOS
?△LOGOPOS
g:LOGOPOS=：ＩＤ>
For all other responses, refer to "Error List."
-1
A "busy" response is given while the zoom or focus lens is being driven.
（Refer to the ZCONTDRV command and FCONTDRV command.）
-2
-3 The user image position can be set by the LOGOPOS command.
> GET LOGOPOS or ? LOGOPOS
< g:LOGOPOS=LOWER_L
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
LOWER_R Lower right
CENTER Center
LOWER_L Lower left
○
○ ○ ○
Description
Response
This inquires about the current user screen (logo) display position.
Setting Meaning
ID
UPPER_L Upper left
UPPER_R Upper right
Commands
Function
Format
User image position inquiry
An inquiry cannot be made if the user image has not been registered.
(The error "e:1002 NO_LOGO_CAPTURED" is returned.）
SX50 SX6 SX60 X600
01.00** 01.01** 01.01** 01.01**
○
Model Power Input
D-RGB A-RGB1 A-RGB2 Comp
Mode
Remote Local
Remarks
Video S-Video D-Video SCART None
SX50 ○ ○ ○ ○ ○ – – ○ ○ ×
SX6 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ×
SX60
X600
This inquiry can be made when the projector is in both the remote mode and power-on status at
the same time.
Commands
supported
Mode Control Setting Reference
Example
PAGE 110