Canon REALiS X600 - Manual (Page 173)

User Command Specifications ９．Details of command RANGE LOGOPOS
1 RANGE LOGOPOS
RANGE LOGOPOS
RANGE□LOGOPOS
r:LOGOPOS=I, , , …,
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
-3
> RANGE LOGOPOS
< r:LOGOPOS=I, UPPER_L, UPPER_R, CENTER, LOWER_L, LOWER_R
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
X600
SX60
○ ○ ○ Ч
○ Ч
SX6 ○ ○ ○ ○ ○ ○ ○
None
SX50 ○ ○ ○ ○ ○ – – ○
Video S-Video D-Video SCART
Mode
Remote Local
Remarks
○
Model Power Input
D-RGB A-RGB1 A-RGB2 Comp
X600
The user image position can be set by the LOGOPOS command.
Reference
01.00** 01.01** 01.01** 01.01**
An inquiry cannot be made if the user image has not been registered.
(The "e:1002 NO_LOGO_CAPTURED" error is returned.)
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
Commands
Function
Format
User image position setting option inquiry
Mode Control Setting
ID
This inquires about the parameter options which enable the user screen (logo) display position to be
set.
For all other responses, refer to "Error List."
(Refer to the ZCONTDRV command and FCONTDRV command.)
SX50 SX6 SX60
Response
○
○ ○ ○
Description
Commands
supported
Example
PAGE 165