Canon REALiS X600 - Manual (Page 142)

User Command Specifications 9．Details of command RANGE HPOS/VPOS
1 RANGE HPOS/VPOS
RANGE HPOS/VPOS
Horizontal position adjustment range inquiry Vertical position adjustment range inquiry
RANGE□HPOS RANGE□VPOS
r:HPOS=N, ,
r:VPOS=N, ,
-1
A "busy" response is given while the zoom or focus lens is being driven.
With some input signals, it may not be possible to make this inquiry.
-2
> RANGE VPOS
< r:VPOS=N, 0, 820
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
Commands
supported
Setting Reference
For all other responses, refer to "Error List."
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
SX60 X600
Horizontal/vertical position adjustment range request
Ч Ч Ч –
Mode Control
SX50 SX6
These inquire about the ranges within which the horizontal and vertical positions can be adjusted.
Number
(Refer to the ZCONTDRV command and FCONTDRV command.)
The horizontal and vertical position adjustments can be set using the HPOS and VPOS
commands, respectively.
Commands
Function
Format
Example
Description
Response
01.00** 01.01** 01.01** 01.01**
○ ○ ○ ○
Model Power Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 Ч ○ ○ – Ч ○ Ч
SX6 Ч ○ ○ Ч Ч Ч Ч Ч Ч ○ Ч
SX60
X600
PAGE 134