Canon REALiS X600 - Manual (Page 41)

User Command Specifications 9. Details of command DGAMMA
1 DGAMMA
DGAMMA
DGAMMA=：ＩＤ>
Dynamic gamma setting parameters
The command is used to set the dynamic gamma function to ON or OFF.
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
Menu
[Image adjustments] - [Dynamic gamma]
[Image adjustments] - [Advanced adjustments] - [Dynamic gamma]
-3
-4
Setting
> DGAMMA=1 This sets the dynamic gamma function to ON.
< i:OK
Reference
> GET DGAMMA or ?DGAMMA This retrieves the dynamic gamma function state.
< g:DGAMMA=1
Acquisition of parameters which can be set
> RANGE DGAMMA
< r:DGAMMA=I, 0, 1
The dynamic gamma can be set using "0" or "1."
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
01.00** 01.01**
○ ○ ○ ○
01.01** 01.01**
Setting Reference
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
ID
ON
OFF
Mode Control
Dynamic gamma
"i:OK" is returned if the parameter was set properly.
Parameter Meaning
1
SX6 SX60
Commands
Function
Parameter
Example
Description
Response
Format
This command is the same as the menu functions in the table below.
0
Model Power Input
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video
Mode
Remote Local
Remarks
SCART None
SX50 ○ ○ ○ ○ ○ ○ – – ○ Ч ○
○ ○ Ч ○ SX6 ○ ○ ○
SX60
X600
○ ○ ○ ○
X600
Model
SX50
SX6
SX60
For all other responses, refer to "Error List."
(Refer to the ZCONTDRV command and FCONTDRV command.)
For details, refer to the GET command.
Commands
supported
X600
This sets the currently selected input signal and image mode.
The current dynamic gamma function status can be acquired using the applicable GET comman
SX50
PAGE 33