Canon REALiS X600 - Manual (Page 140)

User Command Specifications 9．Details of command RANGE DOTS
1 RANGE DOTS
RANGE DOTS
RANGE□DOTS
r:DOTS=N, ,
For all other responses, refer to "Error List."
-1
A "busy" response is given while the zoom or focus lens is being driven.
With some input signals, it may not be possible to make this inquiry.
-2 The total number of dots can be set by the DOTS command.
> RANGE DOTS
< r:DOTS=N, 0, 4096
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
(Refer to the ZCONTDRV command and FCONTDRV command.)
Commands
supported
SX60 X600 SX50 SX6
Ч Ч Ч –
Control Setting Reference Commands Mode
Function
Format
Example
Description
Response
This inquires about the range within which the total number of dots can be set.
01.00** 01.01** 01.01** 01.01**
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
Number
Total dot number setting range inquiry
○ ○ ○ ○
Model Power Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 Ч ○ ○ – Ч ○ Ч
SX6 Ч ○ ○ Ч Ч Ч Ч Ч Ч ○ Ч
SX60
X600
PAGE 132